Ascend Pipeline NAT Configuration

Assume:
 a. Your user name is username
 b. the " --> " in this page means right arrow key of your keyboard.
 c. To save your changes, press Escape Twice, then press 2 - Exit and Accept.

1. open Pipeline 75 User interface
2. Following manu will appear:
        Configure...
        10-000 System
        20-000 Ethernet
        30-000 Serial Lan
3. From Configure --> Switch Type = xx-x       (*depends on telephone company)
        Chan Usage  = Switch/Switch
        My Num A    = xxxxxxx      (*Use your number)
        My Num B    = xxxxxxx
        Spid  1     = xxxxxxxxxxxx  (*Use your number)
        Spid  2     = xxxxxxxxxxxx  (*Use your number)
        My Name     = (your username in lowercase)
        My Addr     = 192.168.100.1/28
        Rem Name    = isdn
        Rem Addr    = 100.100.100.100/24
        Dial #      = 2145551212
        Route       = IP
        Bridge      = No
        Send Auth   = PAP
        Send PW     = <<your password>>
        Recv Auth   = None
        Recv PW     = None
4. From :
Ethernet --> Connections --> isdn -->
        station = isdn
        Active  = Yes
        Encaps  = MPP  (*1B use PPP)
        Dial #  = 2145551212
        Calling#= 2145551212
        Route IP= Yes
        Encaps options.. -->
          Send Auth  = PAP
          Send PW       = <<your password>>
          DBA Monitor   = Transmit
          Base Ch Count = 1 (2 for 2B)
          Min Ch Count  = 1 (2 for 2B)
          Max Ch Count  = 2
          .
          .
          .  (use default)
        IP options.. -->
          LAN Adrs  = 0.0.0.0/0
          WAN Alias = 0.0.0.0
          IF Adrs   = 0.0.0.0/0
          .
          RIP       = Off
5. From:
Ethernet --> NAT.. --> NAT..
        Routing = Yes
       Profile = isdn
       FR address = 0.0.0.0
       LAN=Single IP addr
       Static Mappings...
        .
       . (use defaults)

6. From :
Ethernet --> Static Rtes --> default -->
        name    = default
        Active  = Yes
        Dest    = 0.0.0.0/0
        Gateway = 0.0.0.0/0

7. From :
Ethernet --> Mod Config --> Ether options -->
       IP Adrs = 192.168.100.1/28
        2nd Adrs= 0.0.0.0/0
        RIP     = Off
        Ignore Def Rt = Yes
        Proxy Mode = off

8. From :
Ethernet --> Mod Config -->
       Bridging = No
        IPX Routing = No
        DNS --> Domain Name = wt.net
           Pri DNS     = 129.250.35.250
           Sec DNS     = 129.250.35.251
           List Attempt = No

9. From:
Ethernet --> Mod Config.. --> DHCP Spoofing...-->
       DHCP Spoofing = No
       DHCP PNP Enabled = No

10. From :
System --> Sys Config --> Name = testuser

11. From Configure --> CTR-D --> 1 = Dial